Viking Oil Pump

Viking Oil Pump:
The Oil Viking pump of America uses two rotating gears which unmesh at the suction side of the pump to create a vacuum which pulls fluid into the pump. The spaces between the gear teeth transport the fluid along the outer perimeter of the housing to the discharge side, and then the gears re-mesh at the center
to discharge the fluid.  The gears are supported by bearings on both sides, which allows high discharge pressure capabilities.

The Oil Viking pump, driven by cankshaft through chains. Overpressure bypass regulator is set on the pump. The original setting is 0.4 Mpa,and oil mass of the pump is 25L/min. It provides lubrication and cooling for crankshaft and connecting rod, crosshead, etc.

Features:
With shaft support on both sides of the gears,
Accurate flow measurement,
The more reliable and lower cost.

the Other Related Parts:
 Cylinder
 STAFF High Pressure Valve
 KENCO Oil Level Controller
 Hoerbiger Packing Parts
 Hoerbiger Gas Valve
 Cross Head
 Crankcase
 Crankshaft
 CPI Grease/Lubricator
 CPI Oil Distributor/Divider valve
 Piston Rod
 Connecting Rod
   the More >>